PD-106 With Circuit Board Supports Installed (Actual Size)
| Application Note: To maximize the life of your Clark piston pump it is recommended that supply voltage not exceed 40% of rated pump voltage (16.8 volts for a 12 volt rated pump) and frequency be kept below 40 Hz. The PD-106 is designed for use specifically to drive certain Clark solenoid pumps. Check pump data sheets for suitability or call factory. |
Model PD-106 is a board level product intended for mounting in a customer provided enclosure. It is intended for use with Clark solenoid piston pumps to drive the pumps with pulsed DC power.
The board accepts 9-35 VDC input and has a pulsed 9-35 VDC output.
The pulse length is fixed at a nominal 10ms and the dead time between pulses is adjustable via a potentiometer.
The circuit can drive pumps up to 35 volts.
Input: 9 - 35 VDC
Output: 9 - 35 V pulsed output
Pulse length: fixed at 10 ms nominal
Current output: 1.5 A maximum
Frequency: adjustable via single turn potentiometer, 50Hz maximum
PC Board:
Material: FR4
Surface Finish: HASL, Immersion White Tin
Solder Mask: LPI Green
Connections: 4 position 5 mm PCB connector terminal block
Mounting: Four through holes, 0.156" (4 mm) diameter
Accesssories: Units supplied with four screw mount Nylon circuit board
supports. These mount to customer enclosure/chassis with self-tapping no. 6
screws (not supplied)
Dimensions: 2.50"W x 1.75" D x 0.91" Max. H (not including board supports)
Packaging: 3" x 5" ESD shielding bag
ORDERING INFORMATION
MODEL NUMBER: PD-106
| FOR YOUR CONVENIENCE, THIS ITEM IS AVAILABLE ONLINE, OR PLEASE CALL 1-800-253-2497 TO ORDER | |
| MODEL | DESCRIPTION |
| PD-106 | Pump Driver Board for Solenoid Piston Pumps |
| This Item Typically Ships from Stock | |
|
||||||||||||||||||