Model 00 Rotary Gear Pump

SPECIFICATIONS
GENERAL
Design: Drive speeds to 1800 RPM; discharge pressures to 300 PSI;
   flow rates to 0.5 GPM; foot or flange mounted
Material: Cast Iron casings with precision machined, heat
   treated gears and case hardened shafts.
   Pumps are also available in Ductile Iron.
Gears: Helical gears
Bearings: Plain bearings
Seal: Lip Seal
Lubrication: Self-lubricating using the pumped liquid.
Rotation: Clockwise or counter-clockwise, specify at time of order.
Liquid Viscosities: 32 SSU to 1750 SSU. Clean liquids having good
   lubricating quality. Adaptable for handling liquids of higher or
   lower viscosities.
Suction Lift: Up to 28" Hg / 31 feet depending on the type of liquid being pumped.
Drive Options: A-Drive (pump connected to C-face motor with adapter bracket
   and coupling). D-Drive (pump coupled to motor mounted on base plate.)
Accessories: Repair Kits, Gear Kits, and Seal Kits.

FEATURES

PRECISION GROUND JOINTS
   NO GASKETS - Perhaps the biggest advantage to these pumps. As gaskets
   are not used, original tolerances are maintained for consistent performance
   and the time once lost in halting operations to replace a worn gasket is
   saved.
SEALS
Lip seal provides an ample safeguard against liquid leakage and the entrance
of air.

PUMP DIMENSIONS (INCHES)

Model	A	D	E	G	J	K	M	O	Keyway
00	1.888	3.00	0.41	4.19	0.38	1.63	0.375	3/8-16	Flat

FLOW CURVES

OPERATING CHARACTERISTICS Delivery and horsepower are based on liquid viscosity of 300 SSU at speed and pressures shown.

Model	Gallons per Revolution	Slip GPM/PSI	Drive Speed RPM	0 PSI	50 PSI	100 PSI	200 PSI	300 PSI
Model	Gallons per Revolution	Slip GPM/PSI	Drive Speed RPM	GPM	HP	GPM	HP	GPM	HP	GPM	HP	GPM	HP
00	0.00029	0.0003	1140	0.33	0.13	0.31	0.036	0.30	0.062	0.27	0.110	0.24	0.159
00	0.00029	0.0003	1725	0.50	0.020	0.48	0.056	0.47	0.093	0.44	0.165	0.41	0.238

PUMP DIMENSIONS (INCHES) DIRECT COUPLED TO STANDARD C-FACE MOTOR (A-DRIVE) 00 Series pumps are available direct coupled to a NEMA C-Face foot mounted motor. This assembly, referred to as an A-Drive, ensures accurate alignment and requires less space and is less costly than a pump and motor mounted on a baseplate.

Model	Motor Frame	A	B	C	D	E	G	H	K	L	M
00A	42C	1.88	4.94	4.06	3.50	0.28	13.13	5.38	4.63	1.69	3/8
00A	56C	1.88	7.09	5.16	4.88	0.34	18.13	7.44	8.81	3.00	3/8