UNO
Series D Boxer Pump
DC Power, Gases to 4 LPM, Vacuum to 733 mbar, Pressure to 10 PSI

DESCRIPTION
The Boxer D is essentially two of the Boxer S pump heads powered by a single motor. The double arrangement of ports allows to connect the pump heads in parallel for maximum flow, or in series for maximum pressure/vacuum.

SPECIFICATIONS
Permanent Magnet Motor Ratings: 4.5 or 6.5 VDC
Core Less Motor Ratings: 6, 9, 12, 18, or 24 VDC
Max Free Flow: 4.0 l/min
Max Pressure, Parallel Configuration: 6.8 PSI (0.469 bar)
Max Pressure, Serial Configuration: 10 PSI (0.689 bar)
Max Vacuum, Parallel Configuration: 400 mbar (300 mmHg)
Max Vacuum, Serial Configuration: 733 mbar (550 mmHg)
Tube Connection: ø3.5mm (X4 positions)
Weight: 39g Housing
Material: PPO (Polyphenylene oxide)
Diaphragm & Valve Material: Silicone(S), Nitrile(N) Santoprene(SP)

FLOW CURVE

MOUNTING
A unique feature of the Boxer pumps is the ability to mount the pumps as a push fit into your equipment. The pump has been designed to fit tightly onto the crank-case lid. The lid in this case acts as a fitting accessory for the pump.

Fitting the pump via the lid onto your equipment allows you to remove or replace the pump without the need of any tools. Just push the pump onto the lid and pull it out whenever desired.

The Boxer S pumps have 6 mounting holes and the Boxer D has 8 mounting holes for your choice. Normally two mounting screws are sufficient to secure the pump into your instrument.

The crank-case lid has two blind mounting holes for No. 2 self tapping screws and two through holes for M2 machine screws. You can use the two M2 machine screws in order to mount the crank-case lid either from the outside or the inside of the instrument.

The two other mounting holes (four for the D range), are on the side plates of the pump. These holes are 10mm deep